View Single Post
  #2   Report Post  
Posted to alt.binaries.pictures.woodworking
Bill Rubenstein Bill Rubenstein is offline
external usenet poster
 
Posts: 135
Default Waxilit helped here.

Hm...

I've been doing this for years with Johnson's paste wax. I dry fit m/t
joints, rub on paste wax around the joints, and glue. After the glue
dries, it comes right off. As with the other, get the wax off before
finishing.

Bill

Leon wrote:
Ok, per Charlieb's hint/suggestion I again bought it too. Cheaper than the
Domino.

I ordered a 7 oz can of Waxilit and noticed on the internet that I could
also get 1.6 gallons for about $38. I am glad that I went with the smaller
7 oz container. This stuff does indeed goes a very long way.

Attached is a rather lousy macro picture taken with out a flash and reworked
on the computer so that it would not appear as a black screen.

Please focus more on the joint between the 2 pieces of Rustic White Oak. I
am building a Shaker stile 3 step, step stool and wanted it to have that
"not brand new" look. I wanted to accentuate the joint lines between the 3
levels. If you look closely you might see the joint lines that I did not
want to appear noticeable. Down the center however you will see the joint
line that I wanted to appear. I used a 3/32 radius round over bit on the
edges. I naturally used my new Domino to help align the joint and in doing
so found that pretty much every where there is a loose tennon a bigger glob
of flue will squeeze out. Anyway I though this would be a good test for the
Waxilit. Before gluing I dipped the tip of my finger into the Waxilit and
rubbed some of the product all along the perimeter of the corners. After
gluing and clamping the whole joint pretty much filled with squeeze out glue
and a bit heavier where the tennons are situated.
After letting the glue dry for 2 hours I took a scratch awl and ran it down
the tapering crack at the joint line and all the glue came right out
although some of it was still a bit soft. It came out easily and completely
as shown in the picture. I used a paper towel and acetone to remove the
remainder of the Waxilit.
Can you imagine removing squeeze out all along that crack with out
beforehand preparation?


Thanks again Charlieb