View Single Post
  #6   Report Post  
Posted to
mike hide mike hide is offline
external usenet poster
Posts: 117
Default How can I make this?

"George" wrote in message

"Locutus" wrote in message
I have a 4x4 x 6' post. I would like the center to be cut at 22 deg angle
(I think) all the way around, to give it circular look. The tops and
bottoms should remain square. (maybe with the corners beveled off).

I have a table saw, router table and hand held router and various other
common hand tools.

Is this possible without making it in three sections? I hope this makes

Sure, make a jig to hold the piece and support the router, then face off
the offending portions. Wouldn't be a lot different than any fluting jig.
You do the search.