Unless it's an old house with balloon framing, you will have to drill
through floor plates


"Andrew Sarangan" wrote in message
oups.com...
To isolate noise and heat from the computer, I want to place the
processor box in the basement and have the monitor and keyboard on the
floor above. I need to penetrate the basement wall (which also happens
to an exterior wall), run straight up about 6 ft, and then penetrate
the wall again to get into the room on the upper floor. The run should
be no more than 10 ft, so I am not worried about the cable length or
signal integrity. However, I am not sure if the cavity behind the wall
extends all the way between the basement level and the upper floor, or
if it is closed off at floor level. I don't want to open up the
drywall and find out that I can't route the cables after all. The DVI
cable would need at least a one inch hole to get through, so drilling
something that big through structural lumber would be out of the
question.
Any thoughts?