"ransley" wrote in message
oups.com...
On Jul 9, 4:48 am, Meat Plow wrote:
On Mon, 09 Jul 2007 02:29:27 -0400, MiamiCuse wrote:
Is there any guideline on how much of the expansive foam to use? I
have a
chimney and where it meets the concrete roof tiles the gap is too large
for
caulk or sealant. As a matter of fact I can fit two fingers along one
edge
and there is a small crevice under the tiles as well where they meet.
Even
though I am pretty sure there is flashing underneath I will still feel
better if I can fill the crevice along the perimeter.

I thought I would use those foam that expands, however last time I used
it I
did a poor job of it and underestimated how much to use and it ended up
expanding and cracking the surface I put on top of it. I wonder what
is the
best way to gauge how much to apply.

Thanks,

MC

Buy the window and door foam (blue cap) it expands about half of what the
normal Stuff does.- Hide quoted text -

- Show quoted text -

Do it right and foam isnt it. Its a job for a carpenter who can also
flash it properly


Thanks. I did not explain clearly but this has nothing to do with the
flashing. The flashing is installed between the chimney and plywood roof,
then a layer of membrane on top, then the cement and concrete tiles.

There is no leakage in the roof either. The tiles were cut around the
perimeter of the chimney, and the gap is like a almost two inches wide.
Tree leaves fall in there and some moisture will go under the tiles (but
above the flashing) and come out in the weep holes at the end. I just want
to seal off this gap as well to prevent the leaves and water from getting
under, but there is no leak through the chimeny roof joint which the
flashing is protecting very well.

MC