"Dutch Buckhead" wrote in message
reenews.net...
"Smitty Two" wrote in message
news
In article ,
Meat Plow wrote:

On Sun, 08 Jul 2007 13:37:24 -0400, Dutch Buckhead wrote:

"Meat Plow" wrote in message
...
On Sun, 08 Jul 2007 13:23:38 -0400, Dutch Buckhead wrote:

"Meat Plow" wrote in message
...
On Sun, 08 Jul 2007 13:14:01 -0400, Dutch Buckhead wrote:

Hi folks,

I woke up this morning and had water leaking out of my pool heat
pump.
I
determined that the fitting that attaches the drain/discharge line
to
the
bottom of the heat exchanger had broken. I'm assuming this allows
the
unit
to be drained for the winter or something.

Anyway, the male end of the broken fitting is still lodged in the
hole
in
the heat exchanger. I don't have a tool that can grab it to
unscrew
it.
Does anyone know if something like this is available? Thanks in
advance!

Is it plastic?


Yes, the broken fitting is plastic and it appears the
discharge/drain
tube
itself is plastic as well.

Well I would (and I don't recommend you or anyone else do this) using
a
hacksaw blade cut through the inside of the fitting down to the
threads
of the heater, careful not to damage them, and pry/twist the broken
piece
out in one piece hopefully so you can try to match it up with
something.
Have you any experience with PVC pipe installation/repair? If not
you'll
need to get a plumber.

Thanks for the information. I don't have any experience at this.
Someone
told me I might be able to use a stub extractor or a nipple extractor,
but
the smallest one I could locate is 1/2 inch. That is still much
larger
than
the hole in the broken fitting.

Oh ok then I wasn't sure the size so I guess a hacksaw blade wouldn't
fit
inside anyway. That's an awful small fitting by the way, i was expecting
something around 3/4 or so.

What about an "easy-out" screw extractor?

Do you think that would work for a plastic fitting?

I believe it will do the job................