"jeffc" wrote in message
...

"Bob F" wrote in message
...

"jeffc" wrote in message
...
It was recommended I sand poly interior trim before painting
white. If it's not flat (i.e. it's typical nook-and-cranny cross
section, like most trim nowadays), how do you go about sanding it?

Just use your fingers to wrap it against the surface as you sand.

You guys don't seem to understand the type of trim I'm talking
about. It's not this, but it should give an idea
http://www.bmcwest.com/products/default.asp?cat=11
There's no possible way to sand hundreds of feet of that and getinto
the crevices. That's the way trim usually is nowadays.

There is a way, but it requires patience.

Bob