jeffc wrote:
"Bob F" wrote in message
...
"jeffc" wrote in message
...
It was recommended I sand poly interior trim before painting white. If
it's not flat (i.e. it's typical nook-and-cranny cross section, like most
trim nowadays), how do you go about sanding it?
Just use your fingers to wrap it against the surface as you sand.

You guys don't seem to understand the type of trim I'm talking about. It's
not this, but it should give an idea
http://www.bmcwest.com/products/default.asp?cat=11
There's no possible way to sand hundreds of feet of that and getinto the
crevices. That's the way trim usually is nowadays.

Make patterns and fold -- I've done thousands of feet of similar
mouldings over my lifetime...

--