"DerbyDad03" wrote in message
ups.com...
I have some questions about installing an exterior outlet.

I have a circuit that has 2 exterior lights and an exterior GFCI
receptacle on it. I want to tap into this circuit and add another
GFCI. I plan to tap into the circuit along a run of romex inside my
basement, go out through the house rim joist & deck ledger and then to
the outlet. I plan to run Schedule 40 PVC straight out along one of
the deck joists to the far end of the deck.

Here are my questions:

1 - Is it OK to attach the GFCI receptacle, in an weather proof box,
to one of the joists that support my deck? The underside of the deck
is about 6 feet off the ground and I want to hide the outlet behind
the front rim joist of the deck.

Yes, make sure the unused threaded knockouts are properly sealed (with
sealent) and you must use a "while in use" cover


2 - Assuming it OK to mount the box under the deck, would it be better
to mount the box such that the receptacle faces down towards the
ground or out towards the next joist?


Either way is OK, but facing down, the cords may pull out



3 - The junction box inside the house will be just inside the rim
joist and I should be able to connect the PVC directly to the junction
box. Should I run individual conductors from the junction box, through
the PVC, to the GFCI or is there a special type of Romex for this
application?

Three individual conductors is fine. Romex is fine as long as it's not
considered a "wet location". A conduit in the ground is a wet location, but
I don't believe one strapped to the underside of a deck would be considered
one


Thanks for any suggestions.