Thread
:
Mower engine - UPDATE
View Single Post
#
9
Posted to alt.home.repair
Oren
external usenet poster
Posts: 1,940
Mower engine - UPDATE
On 26 May 2007 14:12:03 -0700,
wrote:
On May 26, 5:05 pm, Oren wrote:
On 26 May 2007 13:38:06 -0700, wrote:
I'm just not sure about the other little channels in that carb (there
are a couple of them there). But I will take the carb apart again and
try to make sure those are clear.
How close are these ("channels") to the primer bulb; presuming,
inside the carb throat? They are "tiny", right? Once cleared from
(shellac/clogs/etc.) your engine should run.
If you try a wire as I mentioned, don't break it off in there.
--
Oren
I have just the wire for that.
I'll see if I can get at it again tomorrow or sometime next week...
thanks
If one of these inlets ("channels") is near the choke butterfly/baffle
in the throat clear it for air.
If one of these inlets ("channels") is near the primer bulb in the
throat clear it for fuel.
--
Oren
...through the use of electrical or duct tape, achieve the configuration in the photo..
Reply With Quote
Oren
View Public Profile
Find all posts by Oren