"Pete & sheri" wrote in message
...
Hi, Ken
Take a look at this link.
http://livesteaming.com/articles/finding.html
Pete Stanaitis
So the gist of this article, the author writes:
1. I tried to buy an ENCO but they were hard to deal with so I didn't,
2. I bought a Grizzly lathe and it is OK,
3. You should buy an ENCO because its cheaper and I *think* it's the same
thing.
Did anyone else find this a bit strange?
Well at least it is free advice :-) if only a small step below the quality
of the typical HSM mag review.
Bob