On May 14, 10:09 pm, John Rumm wrote:
wrote:
I think it's this video (at the 5 minute 50 second mark).
http://video.google.com/videoplay?do...21680103&hl=en

Nice idea closing in the front of the table with a translucent sheet so
that you see what is going on in there. Where is your extraction port,
actually on the base of the enclosure?

Yup, I had come to that conclusion... you look at the top shroud on my
table, and think, yup that is getting most of it. Then you look under
the table and on the floor and realise it wasn't!

--
Cheers,

John.

Thanks John. You are correct, the dust shroud is located at the base
of the enclosure. I used a dust shroud that was designed for the
bottom of a contractor style table saw - it tapers nicely into the
pipe connector.

Here's a decent pic:
http://www.eagleLakeWoodworking.com/...s/P6130093.jpg

Best Regards,
John Nixon
www.EagleLakeWoodworking.com
Buffalo, NY