"Lew Hodgett" wrote in message
ink.net...
Vic Baron wrote:

I have two pieces of oak - 17" x 3" that are beveled 45 degrees
along their
length. I need to glue them to form a 90 degree leg.
snip

A piece of aluminum angle extrusion and some C-Clamps.

Cover the angle with packing tape then use the angle as a form and clamp
the parts to it until the glue dries.

Lew

I'll have to take a look at that. I have some angle iron around somewhere.
By using the corner miter clamp on the top and bottom, I can keep the
alignment. I mainly want to apply some clamping pressure along the length of
the piece.