Let's see, a #10 screw has a nominal diameter of 0.190".
Marks wants a 0.950" hole in it.

Ayup, you're right, Gunner. It cain't be dood.

---


C'mon, Larry, of course it can. As a matter of fact, I've attached some to
this message. They're right he




Since they are a bit tough to see, I should tell you that there are actually
610 of them. You are welcome to forward 600 of them to the original poster,
and I'll split with you whatever he decides is fair.

I ran the extra 10 so you'll have some to keep for yourself and to show to your
friends.

Some were drilled very slightly off center, but he didn't specify any
tolerances and they are close enough for me.

You'll note, of course, that these are silicon bronze rather than regular
brass. I used what I had handy. If he objects, have him supply the original
stock.

Tell him that on the next ones if he wants them reamed after drilling, the
price won't change. I always like to be thorough.

Waiting for my check,

John Martin