Mark wrote:
I'm not a regular here, so please excuse me if this type of post is not
appropriate here.
I will be needing a quantity of 10-32 brass machine screws, .5 inches long
to be drilled down the center with about a .95 size drill. The exact size is
not at all critical - I just want to pass some wires through the length of
the screw while still maintaining some structural integrity.
I would like 10 pieces now for prototyping, but will need about 600 per year
after that. If anyone is interested, please email me at
.
Thank you.
Mark
Is that a .95 mm drill ? 0.095 inch? # 95 ? (that would be one SMALL
drill!)
Be some special trick to drill through a # 10 screw with a drill that's
almost a full inch in diameter.
Cheers
Trevor Jones