Hopefully flush. The riser and the tread above it need to form a 90' angle.
JG
"bremen68" wrote in message
oups.com...
On May 1, 10:57 am, "JGS" wrote:
Hi,

I am laying a laminate floor for a friend. I need to do about 6 steps
too.
In order to install the material on the steps, I need to remove the tread
nosing flush with the riser.

The nosing is about 1.5"thick by 1.5" deep. Any ideas?

The treads extent into the walls therefore I cannot just remove the tread
to
do the job.

Thanks, JG

Are you sure you want to take 1.5" off the stair tread? How wide will
they be after you do this? Just curious.