On Apr 28, 7:12 pm, Kevin Miller wrote:
Prometheus wrote:
On Sun, 29 Apr 2007 00:42:51 GMT, "Tom Storey"
wrote:

If you can find a place that makes wet/dry diving suits, they will usually
sell neoprene remanents and neoprene makes a great backing for velcro and
sticks well with a contact adhesive.

Not a bad suggestion, but I live about as far away from an ocean as
If you check out Vinces site, he talks about sanding, and it got me
thinking. I have the slow speed Milwaukee/Sioux drills which go at
about 1200 rpm. He said that you should be sanding around 600 rpm. I
tried it, and it works just as well as the higher speeds: you get the
same amount of stock removal in the same amount of time, and the heat
is greatly reduced.
robo hippy

anyone can. Probably not a lot of diving suits around, though I
confess I've never really looked!

But I bet you live near a computer store. I have a foam wrist pad that
sits in front of the keyboard that's about an inch or so thick and 3"
wide. I've made several sanding disks with it and still have plenty
left over for more. Just a couple bucks...

...Kevin
--
Kevin Millerhttp://www.alaska.net/~atftb
Juneau, Alaska
Registered Linux User No: 307357