"tom" wrote in message
oups.com...
| On Apr 26, 7:27 pm, "Edwin Pawlowski" wrote:
| "Steve" wrote in message
|
| oups.com...
|
| Hello,
| I will be replacing a badly deteriorating countertop for a kitchen
| sink in an old trailer house we own as a getaway on a small lake.
The
| double sink is in ok condition to reuse I think. I went to Home
Depot
| and bought about the right size formica countertop that would fit
the
| space. Now I need to mark and cut out the opening in the
countertop
| for the double sink. I was wondering if anyone could give me any
| pointers in doing this correctly so I don't end up wishing I had
hired
| someone else to do it right.
|
| Lay the old counter on top of the new one and trace the hole.
|
| And use a downcutting blade in your jigsaw to minimize chipout. Tom
|



correct way for sink installation in laminate top.

use blue painters tape around perimeter where sink will be cut out.
lay sink upside down, place in position on countertop.
measure twice..........cut once.
trace perimeter of sink with pencil.
lift sink up.
measure 5/16" inward (towards sink center) from original trace mark and
connect marks.
measure twice..........cut once.
drill 4 corners with desired paddle bit w/spurs.
cut countertop with jigsaw (w/downward tooth laminate cutting blade as
tom said)

TIP
cut front and back first
screw a piece of scrap to the sink cutout (in center) overlapping the
countertop.
now cut the sides.
the scrap piece will stop the cut out from falling into the hole.

leave a minimum of 2 1/2 in. in front of sink.
and make sure faucet fits behind sink before cutting.