New cabinets will cause the Stove to be repositioned about 1 foot to the
right.
The wiring that went to the light / exhaust vent is to short to reach.
The wires just came out of a hole in the wall, no box there.

What's the best way to extend these wires?

Can I just put wire nuts and tape them?

I'm not sure if there is a stud in the way? I'll explore the hole tonight.
If I have to get on the other side of the stud I may see if I can pull the
old line and run a new line from the attic.

Is it "normal" to not install a box and just run the wires through a hole in
the wall and into the back of the stove vent.

TIA

Steve