On Feb 18, 2:22�pm, "Steve Barker"
wrote:
Unless they're willing to assume the entire cost of ripping it out, and
replacing it all including the tubing work, then I'd leave it alone. *Most
slabs won't run toward a drain, and I personally sure as hell wouldn't want
a 2 1/2" drop in my floor in 14'. *I'd feel like a crazy house. *A good foam
squeegee is what you need.

--
Steve Barker

"d_g_peterson" wrote in message

...



I have a drainage problem in a newly poured garage floor. *Being in
very rural area I had only 1 or 2 contractors to choose from. The
contractor that I hired poured the 4' stem wall, did a great job, but
then failed to follow thru with the slab for amost a month. Kept
saying they were backed up with work. The carpenters that built the
garage claimed to have experience in pouring garage floors, so I
agreed to let them pour. Bad Idea. The floor is 24x28, is 5 inches
thick, and has drain in center. The floor is heated, hydronic pex
tubing. *Although I asked that the pitch be set to between 1/8 and 1/4
per foot, it's not even close. *Using a laser, I measured at MOST only
1 inch drop from perimeter (about 14') to drain center. My math tells
me that 2 1/2 or more is what I should have. No water drains at all
from any point, and there are several "duck ponds". *I suspect
somebody was over-zealous with a power trowel. *The guys that did the
work are willing to make good, but I don't think they have a clue as
to how, so... what to do? *I thought at first maybe there was some
leveling product or something that could be troweled, but after some
googling I get the impression this won't work (wont stick, will crack,
etc.). The responsible party seems to think the only viable option is
to grind the slab to the correct pitch. Ok, but I am worried about
cutting the hydronic tubing, not knowing exactly how deep it is
embedded. *I planned on coating the floor with an epoxy paint, so not
too worried about appearance. *Help!- Hide quoted text -

- Show quoted text -

Well my first home had a garage floor drain and that type of slope, it
was a non issue.

sadly I think ripping it up and starting over is all thats available

If yoiur willing to live with it a BIG discount is due from the
contractor.......

I had a imiliar issue with my asphalt driveway they sloped it the
wrong way and left some puddles which are a hazard every winter,
creating icy patches..........

I would have them rip it up and start over including all new heat
lines. Its a cost of doing business for the contractor and they
WOULDNT do it again!