On Wed, 14 Feb 2007 21:15:24 -0500, "Stoutman" .@. wrote:



"CW" wrote in message
nk.net...
Your saw is way ahead of my Craftsman direct drive and, with it, I can go
from saw to glue up.
"Stoutman" .@. wrote in message
...
Nope, not the blade. Is it the TS (most likely-have a look at my saw
at
my website)? Is it the operator? Not sure, but I am not alone in this
operation.



Ok. So what is your point?

I think it is either that:
A) I am a ****ty craftsman
B) I have higher standards for glue-ups.

For a panel glue-up it doesn't reallly matter if the boards have a
little taper. Glue it up oversize and rip it parallel after. That's
the only time I run the second edge over the jointer.


-Leuf