"Stoutman" .@. wrote in message
...
Are you using a dial indicator to align your outfeed table with the
blades? If not, I highly recommend it. The TS-aligner Jr works well for
this task.
--
Stoutman
www.garagewoodworks.com
No. I've never been able to figure out how to use a dial indicator for
anything. I set it up, then find I need to move it to get another
"confirming" measurement so to speak. I know, I'm stupid in that respect.
I did finally get the jointer working well. Just took a few minutes
setting the outfeed table and blades.
Cheers,
cc