Help with Jointer Setup
"James "Cubby" Culbertson" wrote in message
. ..
I'm not trying to edge both edges with the jointer. I'm just trying to
get my one true edge so I can rip the other edge to parallel at the TS.
I've not had this problem before so I'm assuming an adjustment I made a
few weeks ago to eliminate snipe may have been too much of an
"adjustment".
Cheers,
cc
Good. I thought that when you stated that the jointer tapered your board
that you were trying to prevent the taper. You are really only looking for
straight and flat edges.
|