The outfeed table should be at the same height as the blades. If it's not,
as you found out, snipe results.

"James "Cubby" Culbertson" wrote in message
. ..
Hiya,
I'm having some issues with my jointer and was hoping for some help.
I'm getting a tapered board with the front of the board narrower than the
trailing end (I'm edge jointing). I understand this could
be due to the tables not being parallel or the cutter head is too low. I
checked the tables and they seem
fine. I did lower the outfeed table slightly to where if I put a board
on
it and manually spin the cutter, it moves the
board about 1/2" or so backwards. But now I'm getting snipe. In the
past, I've fixed that by setting the outfeed table to be
just below the top of the cutters. Am I to assume that there is a very,
very fine line between snipe and taper here or
is there something else I should be addressing? I believe my technique
is
fine (hasn't changed in the 10-15 years since I've
been using a jointer with no problems).
Cheers,
cc