"BOB Urz" "sound"@(remove) inetnebr.com wrote in message

Richard Crowley wrote:

"BOB Urz" wrote ...
I had a customer bring in an Infinity KPX00 crossover
for a 6.5" car unit. Coil L2 has burnt marks on it,

You can't measure (or observe) the one on the other side?

While not quite symmetric, the other channels crossovers
coil is burnt worse than the one i am looking at now. So, no
chance for a good part measurement.

How badly burnt?

I've seen some pretty ugly messes based on an heavy-gauge wire choke that
was still OK.

For openers, unless they were burnt open or fused, I'd measure both coils
and see if they still measure the same.

On a really bad day, wind up a coil of the same gauge wire and same number
of turns in the same form factor and measure it.