On Wed, 17 Jan 2007 03:32:31 -0000, Gary Heston wrote:
In article ,
Ignoramus16071 wrote:
On Wed, 17 Jan 2007 02:27:22 -0000, Gary Heston wrote:
In article ,
Ignoramus16071 wrote:
[ ... ] Like little T6061 aluminum plates [ ... ]

Are any of your aluminum plates 1/4" thick and big enough to cut 18"
triangles out of?

No, they are little square 5x5 plates, about 1/8" thick.

I do, however, have 3/8" about 8x14 plate and 1/2" 8x13 or so. Also
aluminum.

Any way to weld them together? I don't mind going thicker, I need these
for decking in my antenna tower. I see a new rotator and thrust bearing
in my future.

I doubt that.

IIRC, I have one about 5" pulley with 1 3/8" shaft hole with keyway
and special tightening screws. I have more, but those I may need.

Price? You can email me; the address you see is valid.

$10 will take it, shipping is $8.10 priority mail flat rate box.

i