On Sun, 14 Jan 2007 14:10:12 +0000, NoSpam wrote:

Why do these jigs specify a minimum worktop width?

I need to join a couple of bullnose bathroom worktops at right angles;
they're about 200mm deep which seems to be smaller than any of the jigs
can handle - any suggestions on how to do it?
I wondered about using the aluminium corner joint strips but can't find
anything for a 14mm bull nose.

Given that the depth is only 200mm you won't waste a lot of worktop by
cutting a straight 45 degree line. You should be able to use the jig to
set that up by just using clamps.




--
Ed Sirett - Property maintainer and registered gas fitter.
The FAQ for uk.diy is at http://www.diyfaq.org.uk
Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html
Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html
Choosing a Boiler FAQ http://www.makewrite.demon.co.uk/BoilerChoice.html
Gas Fitting Standards Docs he http://www.makewrite.demon.co.uk/GasFittingStandards