NoSpam wrote:
Why do these jigs specify a minimum worktop width?

I need to join a couple of bullnose bathroom worktops at right angles;
they're about 200mm deep which seems to be smaller than any of the jigs
can handle - any suggestions on how to do it?
I wondered about using the aluminium corner joint strips but can't find
anything for a 14mm bull nose.

Dave

Poor form to answer myself, but having just found a manual on the Trend
site the answer is blindingly obvious - it's just down to where the
guide holes are drilled. I presume all I need to do is ignore the
pre-drilled guide bush locations and align the jig to suit the depth of
the worktop.

Dave