Hi Hal

Hal where better to look than by the makers of those tools, they will
like you to need more "have to have" tools for all those cuts you could
not make without them, ;-)))

http://www.robert-sorby.co.uk/instructions.htm

Have fun and take care
Leo Van Der Loo
http://homepage.mac.com/l.vanderloo/PhotoAlbum30.html

wrote:
Greetings!
While I have a reasonable grasp of which tools (roughing gouge,
spindle gougle, skew, etc) are used for what - I have seen a few tools
that I can't quite figure out.

I'm guessing someone, somewhere, has a web page that addresses differnt
tool profiles and their intended uses. Or, perhaps better, different
finished turnings, and the tools that were used. Either way would be
helpful.

Any ideas?

aTdHvAaNnKcSe!
Hal