On Jan 4, 3:32 pm, "robo hippy" wrote:
With a variable speed, I use it a lot to put on and remove a
chuck/faceplate, and anything else that screws on. Also I use it a lot
sanding, both hand and power sanding. For some reason I prefer to power
sand the outside in foreward, and the inside in reverse.
robo hippy

The lathe is a "stepped pully design" (I'm sure there's a term for
that) so, reverse isn't going to make mounting a chuck any easier! s
I'll try sanding in both directions, though. Thanks for the tip!

Hal