dave12345 wrote:
I have the Bostitch N88WWB framing nailer which uses 28^ wire weld
nails. I was under the impression that these were considered clipped
head nails because there is a little round cutout on the one side of
the head. But upon looking at the Bostitch website, it says "28^ Full
Head Nails." In comparing these nails to the paper tape ones, these are
simply missing a round spot, while the paper tape nails are a D shape.
So basically, my question is, is this considered a full or clipped head
nailer?

Before using this tool on any job that will be have to be signed off by
a building inpector, check with that local departmnet to get their
blessing. Although Bostitch may already have gotten BOCA approval for
the design, your locality may not be that up to date. Good luck.

Joe