pe wrote:
On 4 Jan 2007 13:27:01 -0800, "N Hurst" wrote:


dave12345 wrote:
I have the Bostitch N88WWB framing nailer which uses 28^ wire weld
nails. I was under the impression that these were considered clipped
head nails because there is a little round cutout on the one side of
the head. But upon looking at the Bostitch website, it says "28^ Full
Head Nails." In comparing these nails to the paper tape ones, these are
simply missing a round spot, while the paper tape nails are a D shape.
So basically, my question is, is this considered a full or clipped head
nailer?

Amazon lists it as a clipped head nailer.

http://www.amazon.com/Bostitch-N88WW...qid=1167945895

They sell a variety of framing nailers and nails. Some nails clipped some full round
Check their nail page.

Amazon says clipped, Bostitch says full round. I am assuming it cannot
shoot both, but I am curious as to whether it is classified as full
round or clipped. Clipped nails seem to be in the 'D' shape. These
nails are an 'O' with just a small semi-circle missing from the edge.

___
/ _\
| |_
\ ___/ That is my poor interpretation of the head.