DerbyDad03 wrote:
A hammer drill and a carbide-tipped masonary bit would be best,
although you might be able to get by with a regular drill.

I doubt you're going to drill deep enough to "puncture" the wall and
let water in.

BTW have you heard of Tap-Con or Pro-Con fasteners? They are screws
that go directly into the concrete without anchors. You drill a hole
with the proper size bit for the screw you will be using and then drive
the screw in with a power driver. One thing to remember: They are
typically used for permanent installations. In most cases, if you take
one out, you can't reuse the hole (unless you upsize the screw).


Todd H. wrote:
I'd like to drill into poured concrete basement walls to set some
modest anchors to secure the tops of some freestanding shelving units
against tipping on top of small curious nephews and nieces who might
decide to climb on em.


be prepared to relocate whatever your installing in case you hit rebar