DIYbanter - View Single Post

Mike Howland

wrote:

In article ,
Mike Howland wrote:

The hybrids seem to address this concern... at least somewhat. I was just
curious about what folks thought. The hybrids also seem to have a
slightly
smaller footprint. I *am* somewhat limited in space so a full-blown
unisaw is out of the question, I'm afraid and if the hybrid was slightly
smaller, all the more room for me in the shop.

Regards,
Mike

Mike, if you've got the $, I believe you will find that for the same
fence rail length, the Unisaw will have a slightly SMALLER footprint
than a standard belt-drive, motor-in-the-back contractor's saw.

I hadn't considered that. I will have to give them a closer look. My shop
space is in my basement (about 33' x 13') so every inch is precious.

Thanks again all for all the replies,
Regards,
Mike