Hi,
ok...so I'm nearly ready to start mounting the plasma mount and I have
a few shield anchors to back-up the resin studs I'm going to use.

I've never used a shield anchor but I can see the principal is straight
forward, stick it in your pre-drilled hole, tighten it up, and bobs
your uncle, the anchor expands and secures the chosen bit of whatever
to the wall..the trouble is, I have about 2cm of plaster between the
thing I wish to mount to the wall, and the actual brick...and I don't
want to waste 2cm of the shield by having the colar of the shield level
with the outside of the plaster...I'd obviously rather have the colar
of the sheidl level with the brick, so as to maximise the amount of
expanding bit within the brickwork...

How do I do this ? Do I search out for some sort of colar type washer
that's about 2 cm long to fill the gap between the colar of the shield
and the bolt head, or is there a way to fit the anchor all the way into
the bric, tighten it part of the way to get the anchor to prime itself
first, then do the final tightening after I'm sure it's going to stay
put...instead of the action of tightening the bolt simply pulling the
whole thing back out until it's level with the outside of the plaster
and mated with whatever I'm trying to secure to the wall....anyone
following me here !?!


Ant.