In article ,
Peter Huebner wrote:
In article , says...

I am contemplating replacing my 14" bandsaw and tablesaw with a bigger
bandsaw. I think I have a handle on the good and bad points of that scheme.
(but if you have any profound insights...)


My 18" saw has a 2 horse motor and I haven't been able to slow it down, nor
make it labour. I have some fairly fine blades at the moment (6 tpi down to 14)
and the speed limit is inherent in how much sawdust the blade can carry out of
the kerf.
Lots of power to spare, in my opinion, on a 6" ripping depth. Might be
different if I went to a 3 tpi blade, I can't say since I haven't tried yet.

-P.

--
=========================================
firstname dot lastname at gmail fullstop com

What I'd like to know is, if the OP goes for an 18" bandsaw like this,
what does he do when he needs to rip two 20" X 96" pieces from a
single sheet of plywood?

--
Contentment makes poor men rich. Discontent makes rich men poor.
--Benjamin Franklin
Larry Wasserman - Baltimore, Maryland -