Boreing Holes ?
In article , SMuel10363 says...
The only comment I could make here is, the fastest way
to get fired from a CNC shop is to walk away from a
machine while it's cutting. That was a real no-no
in the place I work
Nonsense ---I have 23 cnc machine that run nites and week ends with NOBODY in
the shop Ray Mueller
Never had one of them crash? As I said, in the shop
I worked in, the rule was when you were working one
machine, you did not setup, run, or clean out another.
The consequences of a crash there was devastating,
and an observant operator could and did stop problems
all the time before they became "machine down for
repair, for a week."
Jim
==================================================
please reply to:
JRR(zero) at yktvmv (dot) vnet (dot) ibm (dot) com
==================================================
|