On Sun, 01 Feb 2004 16:28:48 GMT, the renowned Bill Janssen
wrote:
Question! How badly will I damage the shear if I cut fiberglass circuit
board material.
I don't expect to do that very often but I can imagine wanting to do
that a few times.
No problem. It will eventually dull the blades, but a hundred or two
cuts? No problem.
Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers:
http://www.speff.com