The pictures are not used as links, but the words under the picture are.

John


"William Noble" wrote in message
.. .
well, all the photo links in the home page are inop for me - I think he
wrote the web page for IE and ignored any other browser, didn't check it
with IE though

the lathe is a medium sized lathe - as I understand it, at least - it
could revive the "cast iron versus steel" debate again. Several things on
the description strike me as either nonsense or at least streching things
a bit - the big bearing little bearing thing - with a sliding headsock
this doesn't matter, and with adequate swing over bed it also doesn't
matter. the SS ways is a bit bogus - I have a lathe with cast ways, I
don't take particular care of it, and the only time I've seen rust is
after turnign oak or when my roof leaked on it -so SS sounds good but may
not be all that important. No mention of vacuum - on a new design I'd
expect some consideration of that

"Bill in Detroit" wrote in message
...
woods wrote:
There are some nice lathes at www.turnrobust.com that are on the level
of Oneway lathes. They offer 18x28 and 25x28 models and have some nice
features like stainless bed ways, big sealed bearings, a sliding
headstock, and a seven year warranty, plus they are made in the USA.
As an option, Robust features a Tilt Away which attaches to the end of
lathe and lets you slide the tailstock onto it and rotate it out of the
way. It is what I categorize as a high end lathe in the 5K price range
and certainly worth looking at.

Are there any owner's opinions out there?

All but a couple of the links are broken ... I get, essentially, nothing
from that web site.

Bill



--
Posted via a free Usenet account from http://www.teranews.com