On Fri, 17 Nov 2006 10:49:39 +0000, George Saridakis wrote:

Hi J,

What make and model do you have that handles the .5 micron particulates?

It's a Bill Pentz cyclone with Torit filters.

Did you research any others before you selected the one you have?

Yes. None of the other cyclones available at the time with adequate power
would fit under my ceiling.


thanks
George


"J. Clarke" wrote in message
...

"Art Ransom" wrote in message
...
If you are trying to keep the harmful dust out of your lungs it is a
waste of money. No repeat no DC will get the sub 5 micron stuff out
of the air, The ones that say they will remove down to 3 microns will
do so after the dust has caked on the filter so almost NO air can get
through. That is the reason that commercial shops have the DC venting
outside. If you can see it it, is not dangerous but under 5 microns
the lungs can't expel it.

Uh, mine has 0.5 micron filters that move plenty of air.

Be careful with your sweeping generalizations.

In any case, the device he is looking at is not a dust collector, it is
an air filter with two stage filtration to 1 micron and is intended to
be used as an adjunct to a dust collector. Its primary purpose is to
clear the fines that remain suspended after the dust collector has done
its thing.

I may build one of those myself one of these days--if I just leave the
cyclone going for a while it accomplishes the same thing but the filter
draws a lot less power.

--
Art Ransom
Lancaster , Texas

www.turningaround.org
"Iznogood" wrote in message
ps.com...
Hello, i am considering buying an air filter for my workshop, and any
thoughts or input from your own experience will be welcome. At the
moment i am looking at the perform air filter from Axminster.

http://www.axminster.co.uk/sessionID...lter-33223.htm


Is i nessecary to change the filters , or can you clean them.

Anders.








--
X:\Newsreaders\sig.txt