Another possibility is that the "main" circulator is not pulling in the same
direction as the three on the manifold


wrote in message
ups.com...

RBM (remove this) wrote:
As Doug and Sev said, disconnect the wire to the "main" circulator and
see
what happens. If the problem stops and this main circulator is not part
of a
manifold, but instead, is inline in the return, I'd remove it altogether



"RayV" wrote in message
ups.com...
My BIL called me over to help him fix a leaking circulator pump on his
system which was an easy swap and fixed the leak. But he still has a
big problem with his system, here's the current setup:

Boiler in basement
Split level house with all zone loops higher than basement
Three zones - all thermostats working properly
Circulator pump on the cold/return side of boiler mounted just above
boiler inlet
comes on with furnace (zone independent)
Flo-control valve on the hot/supply side of boiler mounted near ceiling
Air separater right after main flo-control valve with bladder expansion
tank
Three additional zone circulator pumps connected to the thermostat
relays
Three zone flo-control valves, one right after each zone pump

The problem is that whenever any zone calls for heat there is flow thru
all three zones. I verified that each of the zone pumps are working
indepently and correctly. He told me that the system has always
operated this way and he just sets the thermostat on the upper level to
50 so it never kicks on because he always gets heat up there. On the
zone I changed the pump the flo-control valve stopped the water from
coming out when I pulled the pump. I'm assuming the other two
flo-control zone valves are also properly preventing back flow. But
the problem is they are are always allowing hot water to flow forward
even if the pump for that zone is off. There are no zone valves on any
of the zones, only the flo-contral valves. The zone pumps, flo-control
valves and thermostats appear to be add-ons to the original system.

Does this system need a circulator pump for each zone?
Should there be zone valves installed for each zone?


Sorry....Disagree!! If you are NOT using zone valves then you need a
circ for each zone...PERIOD. If your using zone valves then one circ
wil work as long as you have the proper controller for the zone vavles.
How else are you going to get the hot water to each zone when there is
a call for heat by the thermostat? In my house I have two zones. I
choose to plumb my heating system with individual circulators because I
don't like zone valves. I have a Taco 503 controller that turns on
each individual circ when each thermostat calls for heat. In a basic
hot water boiler setup the only component that will prevent "Ghost
Heating" into a zone that is NOT calling for heat is a check
valve.....PERIOD.

So, don't remove the circ. I would make sure that the valves are
working properly. You should be able to open up the valve without
removing it completely form the system. Now, if your still confused on
this issue all you have to do is call a professional. They will figure
it out for you.

-paul