On Mon, 09 Oct 2006 11:45:04 GMT, (Doug Miller)
wrote:

In article , Prometheus wrote:
On 8 Oct 2006 18:48:58 -0700, wrote:

The sides of the rip fence of my Delta TS350 aren't perfectly
perpendicular to the table. Is there anything I can do about this?
There are no adjustment bolts, as the thing is welded together. Is it
reasonable to complain to Delta when the saw only cost $400?

First off, is it out of kilter in reference to the table or the blade?
If it's parallel to the blade, you've got little to complain about.

If it's parallel to the blade, and *not* perpendicular to the table, then the
*blade* is not perpendicular to the table. That's enough of a cause for
complaint for me to do something about it.

Yes, yes, I caught that- it just seemed like an honest mistake.