Thread
:
Rip fence not square with table
View Single Post
#
8
Posted to rec.woodworking
Pop`ö
external usenet poster
Posts: 16
Rip fence not square with table
wrote:
The sides of the rip fence of my Delta TS350 aren't perfectly
perpendicular to the table. Is there anything I can do about this?
There are no adjustment bolts, as the thing is welded together. Is it
reasonable to complain to Delta when the saw only cost $400?
Mike
Assuming you mean what you said:
|
| side of fence
|
|-----------------
table
that angle not being exaxtly 90 degrees, I'm not sure there's much you can
do about it and it's not likely to make much difference to anything anyway.
For precision cuts you have to get out your ruler anyway, and for
construction cuts who cares? I suppose you could grab a file and start
modifying the handle accordingly, or grind it, but I don't see the problem.
Especially since you included no useful detail other than a general
statement about it.
Pop`
Reply With Quote
Pop`ö
View Public Profile
Find all posts by Pop`ö