oh ok.. I was just wondering....
since your an et guy I've got a question for you. I've been wondering
how difficult/costly it would be to add a digital readout to the unit.
I realize this would have to be a interpolated reading since we're
varing the speed analog instead of digitally as you are using. And of
course what benefit would I truly gain other then it looks pretty. Yes
I have a degree in electronics but I'm rusty as heck. My degree was
focus'd more towards computer repair/engineering then the analog world,
and I never did quite get the analog down. My X was just the opposite.
She got the analog but never the digital... go figure.

Troy

DGG wrote:
Troy said:



OK - I didn't bother to look up your model number, but I believe that
Jet Variable Frequency Drive units have model numbers ending with EVS.
The DC motor versions, like the VS mini lathe do NOT use this VFD.

Now that I think about it, that is the lathe that I replaced with the
Delta. Totally different animals. The 1014 uses a DC motor and PWM
driver. The VFD controllers cost more than an entire Jet mini. ;-)

My bad...