On Fri, 22 Sep 2006 10:52:01 +1000, "glenn P"
wrote:

Actually, cutiing tiles & grouting is the cake end of the job.

Removing the old ones, and preparing the surface are the hardest DIY jobs I
have tackled, and I've tackled quite a few with success...

Really? Prepping the surface on my floor was a bit, but in this case
it would just be putting up new drywall. And I've always been quite
handy with a hammer Someone posted that HD will cut the tiles, but
they won't, so I would have to deal with that. Grouting the floor was
easy enough, and maybe the small lines on the walls would even be;
don't know. Then there's also the small caulk lines.
Anyway, I'm going to patch the part that initially came up at the
bottom (just dremeling the old grout and thinset off; already replaced
the bottom drywall) and try to repair it, then try to use some
water/citrus-based stripper to get the old off, and paint it myself.
Worse case, since we already have the paint, I wasted some time and
start over. Still contemplating getting a spray gun to try the
painting that way, though.

wrote in message
news
Thanks all for your suggestions. I'll see if I can get it done for
$350; I'm guessing it would be more than that now, as the poster said
it's been awhile since his job was done. Otherwise, maybe just
stripping it myself, but then I still have concerns about the paint
job; we've also got a soap dish and towel rack that we'd have to
paint, which seems harder, too.
I figured I'd get a lot of just re-do it responses; I've done patch
jobs on floors before, but don't like the thought of dealing with
cutting tiles and the small grout lines. Anyway, thanks again for all
the responses.

On Thu, 21 Sep 2006 14:26:26 +1000, "glenn P"
wrote:

Just re-tile, when you factor the time used to paint it & prepare it, it's
better spent on doing a proper job. Better resale value as well. Most
punters don't like painted tiles.


wrote in message
...
Our bathroom tile, around the shower/tub, had previously been painted.
We didn't even realize it, as it looked very good. But started peeling
recently, so we decided to try to re-paint it. We sanded the peeling
parts off, which was mainly off the edge of some of the tiles. I
tested one of the tiles with primer and paint, one coat each. It
covers fine in terms of the color, but you can tell where the ridge is
between where the old paint was peeled/sanded off, and where it
remained. I asked at HD, and the guy suggested using lightweight
spackle to raise the lower part and then sand it. I tried that, but
the spackle doesn't stick to the tile very well (if at all; it's
drying now), and it mainly crumbled away. I've always used regular
joint compound for drywall stuff, so this is probably the nature of
lightweight spackle.

Anyway, any suggestions on my situation? I'll try a second coat of
primer and paint and see if that helps, but not optimistic about that.
Should I try getting ALL the old paint off? If so, should I use some
solvent as opposed to sanding, as the sanding of the peeling part
didn't seem to touch the stuff still adhered. Thanks.