I got a jointer...... not sure if I wanted it????
I layed a metal square on the table and could see light under the
middle. Did not use a guage to see how much.
What is the best way to determin if the table needs reground and how to
measure it?
Can any metal rule be used as a straight edge?
Art Greenberg wrote:
On 18 Sep 2006 07:36:29 -0700, stryped wrote:
Did I ruin the table by using silicone? I was going to use wd40 but did
not have any. Or can I remove the silicone with paint thinner?
Paint thinner will not remove silicone.
Actually, they have a surface grinder at work. WIll this get the table true
if it is not already? Will I have to take the whole thing apart to get the
tables to a surface grinder?
Don't attack the tables with any kind of grinder, unless you are certain they
are not flat and true, and you know exactly how much off they are.
--
Art Greenberg
artg at eclipse dot net
|