Do you have a video camera? The tape might help pay medical bills.


"Jamrelliot" wrote in message
...
Do any of you metalworkers know where I can get low cost grinding wheels,
5/8"
arbor, 1/4 and 1/2"thick, 6 or 8" diameter? Wheels need to be this thin so
as
to get the washers and nut back on the arbor. Also to grind a groove into
the
1/2 - 3/4" round and flat high carbon steel.
I'm trying to make some woodworking tools on an old 10" tablesaw. Sort of
use
it as a surface grinder. Cut a groove into an oak 2 X 4, embed and hot
melt
glue the stock into this and slide it back and forth over the wheel and
slowly
raise the wheel. I'll stand in back of the saw, not in front.
Is this idea worthwhile or is it too dangerous? I would appreciate any
guideance. I think it would be fun and save money at the same time.

TIA
Jim