wrote in message
...
Initiated a new woodworking shop endeavor last week and have "anything
goes" on electrical from the contractor and wonder where the "typical"
power source is for the TS whether 110V or 220V. Currently have 110V
TS and it was plugged into a ceiling receptacle and was happy with
that not having to step over a cord on the floor but inquiring minds
wonder what other alternatives exist. Got the X10 for dust collection
that was utilizing the same circuit and enjoyed it muchly. Small
compressor can use either voltage but will probably convert to 220V
for efficiency. Shop/garage will be 24X30 with 9' ceilings with half
bath and drain board/sink adjacent and 3 windows with 18' garage door
and person door. Anxiously awaiting completion! Anxiously awaiting
responses also.
If it were my shop, I would install a 220 receptacle because the extension
could be twice as long before the voltage drop across the extension would
become a problem. FYI, I plug my saw into a 120 receptacle.

O well, the saw never gets more than 20 feet from the receptacle.

Jim