Squeeking V-belt
Hello group,
I proudly set-up my recently acquired jointer (Kity 16", 5.5HP) in my
basement. To get it down the staircase, I had to take it to pieces. Also
the motor had to go out.
Everything is back to work now but:
When turning on the machine, for about a short second, a squeaking noise
is produced by the machine. Further investigation shows that the main
drive V-belt is skidding on the smaller pulley until the main shaft is
at full speed.
Most probably, I got some grease on the belt when putting together the
machine. Already cleaned it up with methylated spirit; €“little help.
Tension of the belt seems to be o.k.
Im afraid to wear the belt pretty soon. What should I do? Further clean
it, put some €śbelt spray€? on it (seen on the internet, no clue whats in
there)?
Any recommendations?
TIA Matthias
|