Speed was a little fast but I was not getting any heat build up or charring
on the other holes I had drilled. The bit was cool enough to hold with out
doing more then causing discomfort after drilling and had time to cool
(about 15 min) between holes.
"CW" wrote in message
ink.net...
If the temperature was high enough to cause ignition, speed was more than
just a little high.

"sweetsawdust" wrote in message
.. .
And how did I do it "wrong" If you have a better way please enlighten
me.
Speed may have been a little high but not that much for the cut in end
grain, clamping was tight etc..