On Sat, 15 Jul 2006 22:44:52 +0100, Andy Hall had
this to say:

I have a need to cut quite a number of lengths of galvanised steel tube
(about 30)

25mm ID, 33.7mm OD e.g. http://www.fhbrundle.com/tube-14.htm

A hacksaw is going to become boring for doing this quite quickly I think so I
am looking for a faster alternative.

Is this angle grinder territory? If so, can anybody suggest a suitable
cutting wheel?

Otherwise, is a more substantial saw like a cutoff saw required?

I would use a power hacksaw.

Then again, I have ready access to one!

--
Frank Erskine